Barnes PGPP2022 Series Cast Iron Grinder Sewage Pump - 2HP - 3450 RPM

Product Information:

About the Barnes PGPP2022 Series Cast Iron Grinder Sewage Pump - 2HP - 3450 RPM

The Barnes PGPP2022 Series Cast Iron Grinder Sewage Pump is a safe, dependable, and aesthetically pleasing. This pump is equipped with a sealed pressure switch eliminating costly maintenance frequently required by float systems where grease is needed or in mercury float switches and banned or restricted. The Barnes PGPP2022 Series Cast Iron Grinder Sewage Pump also has a very dependable centrifugal grinder pump that eliminates wearing components for worry-free operation. This pump is also equipped with a low profile, non-rusting alarm box with a silence button. The alarm features both a light and a horn notification that will signal in the event of any pump malfunction. The Barnes PGPP2022 Series Cast Iron Grinder Sewage Pump is equipped with a lockable rock-shaped which makes the system completely childproof and safe. The unique rock-shaped design also blends well with the landscape, reducing visual impact, allowing the system to stay out of sight and out of mind.

The Barnes PGPP2022 Series Cast Iron Grinder Sewage Pump requires very little maintenance. All the maintenance is performed from the topside so confined space entry is never required. The cover of this pump is easily removed by simply unlocking the padlock and then twisting the cover to unlock and then lifting it off. The level control can also be easily removed without handling the pump. The pump-mounted check valve, discharge diaphragm, and anti-siphon valve are also easily serviced. The Barnes PGPP2022 Series Cast Iron Grinder Sewage Pump features a pre-attached two-point lifting harness that allows for quick and easy removal of the pump with no unbolting required.

Additional Information:

Brochure/Manual

Features:

• Recessed vortex impeller design easily handle finely ground solids generated by the grinder
• Exclusive Slicerator eliminates jams by applying the full torque of the motor on one small section of the cutter ring at a time
• Heavy-duty 2 hp motor with oil lubricated upper and lower ball bearing standard for minimal wear
• Heavy-duty industrial silicon carbide seal for extended usage
• Large pump end bearing and short shaft overhang significantly extends mechanical seal life by reducing shaft deflection
• Reliable Solid Start Switch provides longer life-cycle and improves mean time between service calls
• Oil-filled motor enables the pump motor to run cooler under severe operating conditions

Specifications:

MOTOR:

• Oil filled 2 HP Motor
• 240V / 60Hz / 3450 RPM / 10.5 Amps (18.6 Locked Motor Amps)
• Discharge: 1.25” NPT, Female, Vertical, up to 100 ft head

DESIGN:

• Centrifugal Pump Design
• Submersible
• Cast Iron Body, and Vortex Impeller (open pump out Vane on back)
• Cast Iron Motor Housing
• 416 Stainless Steel Shaft
• 300 Series Stainless Steel Hardware
• 30ft Power Cord
• Automatic Operation with piggy-back float